Adjustable Semi-diameter Arced Concrete Column Formwork for curved wall
Descrition:
It can be used for any curved wall with the semi-diameter longer than 1.10m
Adjustable acted Formwork Profile
Adjustable Semi-diameter Arced Formwork On the basis of the foreign company technology, we developed the
Adjustable Semi-diameter Arced Formwork, which can be used for any curved wall with the semi-diameter
longer than 1.10m. Traditionally, the formwork is produced in accordance with the designed semi-diameter,
which is one-off use, causing much material wasting. All the defects of the traditional formworks are overcome
after we developed the Adjustable semi-diameter arced formwork. Also, we lease the formwork out to the contractors
to save their cost, which proves good effect.
Adjustable acted Formwork's panel is 18mm Plywood,because the panel specification is 2440×1220 mm,so the formwork
max width is 2440mmUpright rib is combination steel frame ,the panel and the steel frame is connected by bolt ;
Horizontal rib is short Double-side V-iron , there are adjustable connectors between V-iron.Upright side-rit is angle steel .
The radius can be regulated at any time when meet to different section. Adjustable Acted Formwork Technique parameter:
Allowed Load50-70KN/M2 Per square meter65KG
Advantage of the product
Can be adjusted to any curved wall with a semi-diameter longer than 1.1m
Easy and quick operation.
Low cost and wide use.
High standard elements.
Assembly procedure
1. Assemble timber beam and timber connector.
2. Assemble plywood and edge rib.
3. Assemble adjustable system.
4. Assemble connecting waling.
5. Adjust the formwork, make the formwork bent into designed radius.
6. Connect every module by adjustable steel clamp.
One plan sketch is shown below
Product Tags:
|
|
Adjustable Semi-diameter Arced Concrete Column Formwork for curved wall Images
|
